There are different types of computer equipment, and of course, it would no doubt deal with a computer at a time and discover the problems associated with the simple. However, we know that if something goes wrong in our computer, we are not fully aware of what happened exactly, or rather, what computer hardware is at the origin of the problem. Therefore, I decided that I article in such a way that we will present the first problem and then go to hardware problems, instead of watching the computer equipment of the and the problems it may cause. Let's start with the basic computer hardware troubleshooting steps it immediately.
Problem # 1: Computer does not start
If your computer did not all have them enabled, the problem is very clear. It has something from the power supply system of your computer.
Troubleshooting procedure.
It is one of the procedures to resolve problems with the computer hardware that can be very simple or can go much further than your ability to solve. The solution can be as simple that the power cable must be replaced by a new or convoluted that dealing with the highways of the computer system. Highways is switched mode Power Supply, in the upper left corner of your processor which powers of each component in your computer. If the problem is with the SMPS is then solve the is not a DIY tasks you can take home. It will have a good technical expertise to solve the problem. Often, perhaps the problem is only one solution, which replaces the SMPS computer.
Problem # 2: Computer freezes or quits unexpectedly
If you are facing this problem that your operating system stops suddenly is no longer, or the computer itself, then there may be some related hardware problem here. Before starting with advice from computer hardware to resolve this issue, I must tell you that most of the time, these are problems with some software is running in your system or in the installation of some wrong driver. However, assuming that you have checked all these problems and know that the problem is not related to the software from your computer, start with computer hardware, troubleshooting part.
Troubleshooting procedure.
Most of the time, it is a problem concerning heat issues. If your computer processor is heated, there are chances that shuts down your computer. The probable cause of this problem is that the fan in your processor does not work correctly. Here, I suppose that you use a desktop as a laptop computer, should of course be much expertise. You can make out or rotate well fan, is simply the observation in the back of your CPU. There are also some screen system programs this show or your computer processor is about heated or not. If you are fan not smooth, you have connections with your verified fan. Another step, you can draw is that you must observe if the BIOS can load the fan well when you start the computer. However, if you discover that your computer fan is functioning properly, and then you consider new hardware had added you to the system. Try deleting that and check if the computer restores back to good works. There is a chance that this material may be defective. Replace new hardware with this. Yet again, if you have a new computer is not added to your system recently, the reason could be a part of computer equipment that already exist in your computer. Open your CPU Cabinet and remove an additional RAM or an additional hard disk that you have used. Verify that your computer without the specific part works. You can also try unplugging your MODEM to verify that the computer works correctly.
Problem # 3: Computer boots only floppy drive
If your system startup, you requirements system to insert a floppy disk to install the system, it is likely there is a problem with the hard disk of the system.
Troubleshooting procedure.
Part troubleshooting before and in view of the disk hard is damaged, discover in the settings for the BIOS if your hard disk the first priority for startup. If it is not the first priority is given, and then edit the priority and the hard disk on the first level of priority of the. If this does not help, then probably the hard drive of your computer is damaged. In this case, you have a restore or a backup system on your computer, then use it to restore the data and the operating system. The other possible solution is that you need to reformat your hard disk. If you want to learn, reformatting a hard disk, and then you can refer to the article, how a reformatting of the hard disk.
Computer hardware tips that I have provided in this article are for the most common hardware problems that you can get. If a deeper understanding on how to deal with computer equipment and repair more complex issues, you in the details of the operation of this particular hardware device. For more information about how to troubleshoot hardware, read articles, repair of computer equipment and the maintenance and repair of equipment: computer hardware troubleshooting tips and tools
No comments:
Post a Comment