Installation of a (NIC) Network Interface Card

Installation of computer equipment may seem a difficult task, but is a two step process. In the first stage, you must connect to the hardware and you to the next step to configure the software that comes with. Before you install new hardware, there are a few facts to consider. Windows XP automatically when connected to all the hardware products it distinguishes and installs the software too. Most of the time, you receive the software with the hardware device or you will need to download the software from the manufacturer's Web site. (NIC) network interface card or a LAN adapter is a component material that access to a system of network addressing medium- and low level through the use of MAC addresses. It also helps users connect with each other by cables or wireless networks.



Installation of a (NIC) Network Interface Card

Disconnect the PC to prevent electrical hazards before installing NIC. A static electricity discharge belt wear while working with the PC, the PC components to protect against damage. Install network interface is quite simple. However, before you always check the available slot and lock type. The majority of the PC uses a PCI, while previously an ISA slot which is now obsolete.



Steps to follow during the installation of a network adapter are:



* Your PC offshore and disconnect. Remove the screws on the sides of the case on and slowly slides the two panels.

* Find an empty PCI slot and remove the metal support plate taking the screws holding slowly scroll it up and out. To do this with the help of a flat-blade screwdriver or pliers, take care of the sharp edges left behind.

* Remove the NIC from the anti-static bag and place it on the slot with the jack to the exterior of the PC.

* Press firmly the NIC so that the mounting bracket is well aligned with the slot. Rocks gently map end to assure in the slot, so that contacts or on the bottom of the network card disappears completely in the slot. The card must be straight and even.

* Replace the NIC Stirrup on the case with a screw and reconnect your machine. Plug the ethernet on RJ-45 connector cable and the other end in the modem DSL, hub, router, or on another PC directly. This is the hardware installation is complete.

* The network adapter comes with a disk containing the drivers required for the installation of the software. Follow the instructions of the manufacturer during the installation process. Follow the wizard network - settings control panel start. This can save lot of time and effort by setting up the network and configuration for you.



During the installation of the network adapter, if you use a wired network problems, check the physical and knowledge connections if your machine is recognized by the hub, switch or router. Also, see the network configurations. If you have a wireless network, check the antenna and the security institutions as it does not automatically define and you also need to have a WEP key to log on the network.