If you have not read my two previous articles on how to remove and a CPU for the installation you definitely itself out of the ground at any time before you start working in as a computer case prep.
You must not on carpet, wear sweaters and something which will create a static load by simply moving.
Stick to metal or just have a part of your body based on the metal in a chassis of the computer will help you from the ground. Must also have all the power off the coast of the computer and unplug the cord.
If you have not already, delete the old CPU. There is a lever that can be used for the disposal of the old CPU. This lever, either plastic or metal, slide out and can be increased if the CPU socket.
Do you want the old thermal paste remove the heat sink, scratch it all. You can use alcohol or any other type of cleaning to verify that it is all gone.
The new CPU can install reverse in the same exact way. Check the pins align properly, there must be a diagonal angle of the pins. Make sure that the diagonal lines of border with the diagonal border in the CPU socket.
There must be zero insertion force going into the CPU socket with the processor. In fact, officially ZIF sockets that I explained just what means ZIF are called: Zero Insertion Force.
The processor should just drop and drop into the socket after the exit of at the top of the socket. This processor with the lever mechanism that you use to get out of the former lock protection.
If by chance spoil you the pins on the processor in most cases you can't fold support. They bend, so be very careful and take your time and your patience.
Now, you can place the heatsink at the top of the CPU and the socket and ensure that the heat sink lines locking mechanism up with tabs of socket that allows secure and prevent the moving body cooling.
You can reuse the screwdriver flat heat press and latch the heatsink Assembly weapons lock sink of heat lock meeting on socket tabs.
This may seem frightening because there could be a significant amount of force is necessary for the poor in place and locked heatsink on the socket tabs. I have a flat head violently in the motherboard, an hour or two in the past. Fortunately survived.
Modern heat sinks generally have a slot in the upper part of the lever arm where you deliberately flat head in place and will not slide out, allowing you to one side of an arm firmly and who can well pressed.
One side of the arm of heat sink, you will be able to put in place probably with one hand. And then you will want to keep the heatsink in place with this hand, this will not be around rock and press down on the other side of the tab in socket of the dissipative arm of heat with the screwdriver flat head.
Once you have the heat sink to have obtained the processor on top of the CPU socket, you should be good to go. Just replace the fan if there was one, and you should be good to go.
You should now be able to turn on the computer after you've buttoned all the tips that you had to remove so that you can work in the housing.
Quilt sets
When comfort counts & quality.
No comments:
Post a Comment